Ventura Aerospace Expertise with System Integration

Posted by:

Ventura Aerospace has been integrating National Instruments cRIO based systems for many years. These particular units use EtherCAT expansion chassis for dramatically increasing the I/O capability of the host cRIO Controller. Included in these units is I/O protection and a fail-safe multi-channel SSR board designed by Ventura Aerospace. With multiple connections on the front panel these units can accept either industrial or mil-spec connections to the I/O. These units are mounted on sliding shelves for integration ...

Continue Reading →
0

8 Channel Failsafe SSR with isolated load sensing circuit

Posted by:

VA-LOGO-NEW-BW

Ventura Aerospace was presented with a unique challenge from a customer. Their current Solid State Relay (SSR) solution for opening and closing a valve was experiencing start up failures. The typical failure mode of an SSR is to fail to the closed position. The problem was that if the SSR failed at start up the connected valve would open out of sequence resulting in possible test article damage.

Continue Reading →

0

Join us at NI Week 2014

Posted by:

Ventura Aerospace will be at NI Week 2014 in Austin! Once again, our system engineers are packing up to attend NI Week in Austin. They are looking forward to the tremendous opportunity to connect with and to learn from some of the best talent in the industry. NI Week brings exciting insight into new hardware that can be used in our Flight Test Solutions and Embedded Systems.

With applications ranging from structural and production ...

Continue Reading →
0

Operational Loads Monitoring System (OLM) system for 10-Tanker

Posted by:

Onboard Level Monitoring

Ventura Aerospace has developed an Operational Loads Monitoring (OLM) System for 10-Tanker. This system has numerous inputs to monitor the structural health of the air frame during all modes of flight and includes acceleration, air speed, strain gauge, retardant tank and GPS data. Data is automatically recorded for download and reduction via ...

Continue Reading →
0

Ventura Aerospace Develops Custom Pressure and Vacuum Test Unit for Fuel Tanks

Posted by:

Ventura Aerospace has developed a custom pressure and vacuum tester for fuel tanks using a National Instruments sB-RIO and LabVIEW. This unit will control pneumatic valves to cycle the pressure in a fuel tank while measuring pressure and strain data on the fuel tank walls. All wiring and integration of the components was accomplished by our wire harness shop. This particular unit will be used for certification testing ...

Continue Reading →
0
Page 3 of 7 12345...»